Determining the Network Topology for HyperScale Edge

Determining the network topology is a crucial first step that can affect nearly every part of the HyperScale Edge deployment in your environment.

HyperScale Edge software leverages several technologies that are critically dependent on a fast and stable network connection. Due to that, there are guidelines on how the network should be configured to ensure that the appliance is stable and meets the performance expectations.

Important

Several pre-defined topologies have been validated and built into the software. These validated topologies are explained below.

If the network topology in your environment is not listed here, or if you are not sure of the topology that is required for your environment, contact your Commvault Cloud representative for assistance.

Answering the following questions will help to determine a recommended topology:

Do you require network redundancy?
Do you have a dedicated non-routable backup network?
Do you require the appliance to be connected to multiple vLANs?

Use the following selection guide to determine the topology required for your environment:

Require Network Redundancy	Have dedicated non-routable backup network	Require multiple VLANs connected to the appliance	Recommended Topology
No	No	No	Basic topology

Yes	No	No	Bonded topology

No	No	Yes	VLAN topology

Yes	No	Yes	Bonded VLAN topology

Considerations

For proper operations, the HyperScale Edge node require connectivity to the following networks:

Data protection network, which transfers data to and from the clients being protected and connect to the CommServe server. This will require a minimum of at least one dedicated 10 GbE network connection.
Optional Management network which is used only when the data protection interfaces are non-routable, and an alternative interface must be used for management.